You're currently on:
Thermaflow Electric Combi Boiler Technical Information
The side-by-side graphics will help to identify the components and layout of the combi boiler as well as illustrating the component accessibility.
Description
- low pressure switch
- high limit thermostat (non resetable)
- safety relief valve 300kpa (3 bar)
- tundish (if required)
- enclosure for 16 amp circuit breakers
- 22mm dzr compression bend
- pressure gauge
- filling loop
- grundfos circulating pump (ch circuit)
- 22mm single check valve (ch flow)
- central heating return
- primary expansion vessel - connect into central heating return
- drain point (primary)
- drain point (potable)
- cold water inlet
- single check valve (cold water inlet)
- heating element no 1
- aqua stat
- 22mm flow switch (domestic hw)
- heating element no 2
- enclosure - pumps, aqua stat, high limit, flow switch and low pressure sensor
- grundfos circulating pump (hw circuit)
- heating element no 3
- heating element no 4
- potable expansion vessel
- hot water blending valve
- hot water outlet
- brazed plate heat exchanger
- primary inlet to heat exchanger
- stainless steel primary store
- automatic air eliminator
This diagram of the Thermaflow electric combi boiler is for illustration purposes only. Thermsaver have made every effort to ensure that the information given on this page is accurate, however this information may change as a result of continuing product research and development.
Please use our Enquiry Form if you have any unanswered questions or for any further information you may require.
thermsaver is the company to rely on
with products you simply fit and forget